Setting up BiXBiT USA Firmware Using Whatsminer Tools
This is for after installing the BiXBiT USA Firmware
If you have not already downloaded BiXBiT USA Firmware, use the following link to do so:
If you have not downloaded Whatsminer Tools, use the following link to do so:
Step 1: Double click on the miner you want to Program.
Step 2: Log into your Miner.
(Default Username and Password is (admin and admin)
Step 3: Go to Configuration.
(1) then select Miner Configuration (2) to input your mining pools. Make sure remember to click “Save and Apply”
Step 4: In the same page click on the overclock tab.
Step 5: THIS STEP IS ONLY FOR IMMERSSION MINING CUSTOMERS!
If you are immersion mining, click this box. Make sure to click “Save and Apply” when you are done.
Step 6: Click on generate profiles.
(This could take about 20 minutes to generate all profiles)
When the pop-up window opens click “OK”
Step 7: Select a Profile. (1)
Click “Save & Apply” (2)
Step 8: Wrap-Up and Quick Start.
And that’s a wrap! Post-selection of your miner profile, give it a solid 15 minutes to get the initial auto-tuning squared away. Once that’s complete, whenever you reboot the system again it will take 3-4 minutes to startup. Don’t forget, all those profiles you’ve dialed in before are stored and ready to roll. Choosing them next time? You’ll be up and hashing faster than you can say ‘blockchain’—smooth and speedy.